Introducing Hex°

Hex° is a filament dehydrator that will restore your filament with a push of a button.

Simple and Effective – Literally works with JUST a button. No complicated settings or interface.

Built with Science – Powerful setup can dehumidify the chamber in only 10 minutes with minimum power consumption.

Maximize strength and quality – Perfect prints avoid time consuming post processing treatments.

Say Hi to smart engineering.

Why Hex°?

Something that actually works.

 Simple. Just push a button. 

We designed Hex° to be as simple as possible because restoring your filament is actually a simple process. The only goal in mind: GET THE WATER/HUMIDITY OUT.

Presets? More like primadonna.

Since you cant over dry filament (unless you melt it) presets are useless and confusing. Wouldn’t it be much easier to push a button and not worry about it?

Design.

True 360° Convection

The body of Hex° is not only cool but designed to enable all around moisture extraction by convection process.

Powerful Fan

A fan pushes the heated air around and around, giving every part of the filament their fair share of heat, resulting in an evenly dried end product.

Interior LED

A blue LED can readily turn on and off to show off your 3D setup. Gets the job done and also look super cool so you can brag a little. ( oh and you can see your filament but who cares other than if it looks cool )

Energy Efficient.

Every bit of energy is used for the drying process and almost nothing else. Plus, Hex° will automatically lower power consumption after the first drying cycle ensuring moisture is out of the filament while being environmental friendly.

Not all ideas are created equally.

THETA° designed Hex° to perform only one function, dehydrate.  No fancy screen and exaggerating heating elements making best use of 48W. No screen, no extra functions, no wasted electricity.

Included STL Files

V Slot Stand 

Wall Mount Attachment

                      Using TPU filament

 Results with Hex° 

Built with Science.

The Data.

Data acquired with Arduino UNO R3 with DHT11 Sensor in FULL POWER MODE

•  [48Wh Consumption] [10 ~ 12 hour span]
•  [75% Auto Energy Reduction after first cycle : 36Wh Continuous Power Consumption]
•  Tested in the toughest environment [ Humid summer in New England ]

For Commercial, data is gathered to illustrate the wrong feedback when the temperature is recorded near the heated plate.

• For Hex°, temperature is recorded from the middle of chamber for a real average temperature throughout the chamber.
• DATA demonstrating Heat without forced convection doesn’t only provide inaccurate temperature readings, but also results in poor extraction of moisture, even if filament is in close proximity to the heat source. 

FAN FAN FAN!

Noisy ? Be the Judge.

First Prototype

REWARDS

THETA° has developed a functional filament, PLA°X contains antifouling properties that kills bacteria, viruses, and microorganisms on contact. Samples come with every reward tier.  Can be used in…

• Fishtanks

          Decor that wont grow algae 

• Bathroom

          Toothbrush holder that wont grow mold

• Kitchen

          Sponge holder that kills bacteria

• Etc…

         Contactless door opener

         Sanitizing phone case

         3D printed clean Facemask

 

 

SUPPORT THEIR CAMPAIGN: https://www.kickstarter.com/projects/theta-cell/hex-a-filament-dehydrator-that-actually-works-0